  |
|
 |
|
 |
|||
| |||||||||||
|
|
This is tailored to a numeric (beeper) kind of page. It assumes no pre-defined information at the server. You will pass in all necessary information to send the numeric page. Example NTPAGER SendNumericPage -AreaCode"602" -AccessNumber"5551212" -Message"5551212" Note: Assumes that you have previously used the SetDefault command to set default values needed for communication with the NTpage Server. Required parameters AreaCode AccessNumber Message Note: The VALUE for the Message parameter needs to be numeric for this command. Since it is sending to a numeric pager. Optional parameters Delay1 Pin Delay2 BeepEndStr From Subject PageDelay IpAddress NamedPipeAddress DebugFile |
|
